Computer ECM, 1998 Camaro/Firebird LS1 5.7L V8 Computer ECM Used. We have a lot of used ECM's, shipping is not included, call or email for a shipping quote. NOTE: MUST CALL TO ORDER 1-864-855-2694

This harness is a direct plug and play harness for an engine swap, PCM Swap, or just a slimmed factory harness in your 1998-2002 LS1 Camaro or Firebird (all required connections will be present, only emissions present are front oxygen sensors, evap, and...

The DiabloSport Trinity T2 line of handheld monitors and performance programmers are some of the most advanced modules on the market. With a multitude of features like full re-flash/reprogram capabilities, advanced data acquisition, logging and...

The DiabloSport Trinity T2 line of handheld monitors and performance programmers are some of the most advanced modules on the market. With a multitude of features like full re-flash/reprogram capabilities, advanced data acquisition, logging and...

THE PERFECT INSIGHT! Observe and understand your vehicle parameters using Edge state-of-the-art technology. Our Insight CTS2 delivers unmatched monitoring capability for any OBD II vehicle (1996 or newer). This digital gauge display works well with...

Superchips Flashpaq Power Programmer Tuner, Call for more application information.   Fits: All 1999-Up Gen III/IV (LS-based engines),  Chevy Small Block Gen V, Chevy Big Block Gen VII, GM Duramax Diesel, GM V6   The all-new Flashpaq...

This MSD 2-Step Launch Control is designed for GM LS Series Engines with Coil-per-Cylinder ignitions. It can be used with 24x or 58x trigger wheels. The 2-Step Control will provide consistent launches and quick 60-foot times. RPM adjustments...

CALL FOR AVAILABILITY!! 1-864-855-2694 Computer ECM, 99-02 Camaro/Firebird LS1 5.7L V8 Computer ECM Used. We have a lot of used ECMs, shipping is not included, call or email for a shipping quote.

Computer ECM, 1998-2002 Camaro/Firebird 3.8L V6 Computer ECM Used. We have a lot of used ECM's, shipping is not included, call or email for a shipping quote.

Camaro/Firebird LSX 2 Bar MAP Sensor, when going with forced induction you always need to change over from MAF to Speed Density which you will need this MAP sensor. N/A cars should change over the Speed Density after 480rwhp.   Note: The 2 bar MAP...

The BIM-01-2-HLLY is designed to read the engine information from the Holley Terminator (including X and X Max), HP, Sniper, or Dominator EFI kits. The BIM-01-2-HLLY module is a direct plug in using the supplied 2 or 4 pin harness for simple connection...

The BIM-01-2 OBD-II (J1850/CAN) Interface allows you to plug directly into the engine diagnostic port, extracting engine and transmission data from the vehicle's computer (ECM). The BIM-01-2 will collect and output the following...