PCV can set up with -10,12 AN inlet from driver valve cover using included adapter for 1000,1200hp capacity; and super check -6 exit to intake manifold THESE ARE NOT RECOMMENDED FOR ROAD TRACK CIRCUIT USE -The 1200 kit uses an oil fill cap...

82-2002 F-Body Ring and Pinion for Hawks 8.8 Rear End

82-02 F-Body Hawks 8.8 Hard Brake Lines New stainless steel brake lines not only look better but fits the 8.8 better than the originals that were designed for a 10 bolt. NOTE: LT1 and aftermarket brakes - you will receive a new center line but use...

Billet Aluminum Backing Plates for 1993-1997 Camaro/Firebirds. ***MADE IN THE USA*** These billet aluminum backing plates are designed to be used on LT1 style 10 bolt rear ends. The are designed to work with 3 channel NON-TSC and 4 channel TCS...

1982-02 F-Body 8.8 Rear End Axles. Includes studs. Available in the following spline: 31 33 35 - SPOOL ONLY  

Hawks Motorsports is pleased to offer our clients the following. This dedicated reservoir is designed for compatible supercharged 1998-2002 Chevrolet Camaro and Pontiac Firebird builds using a liquid-to-air charge-cooling circuit. It provides a...

GM Gen V L86 L83 Engine Swap Conversion A/C Line Compressor Adapter Fitting If you are doing an Gen V L86/L82/L83 engine swap and are looking for a way to make some custom A/C lines then this is your answer. Made from billet aluminum this...

Rollmaster IWIS Seamless LS C7R Timing Chain This seamless chain uses a proprietary pin and Link design that make the pins between link solid, for a better contact surface between the chain and the gears. The solid links also provide greater chain...

Now available Re-Useable T56 Shifter Seal Gasket for the 93-2002 Camaro  / Firebird and 2004-06 T56 6 Speed Shifter.    

Hawks 90° Rubber Hose Fittings are designed with 360 degrees Swivel Ends. -10 AN Rubble Hose End. -10 AN Female. E-85 compatible. These fittings can be used on a variety of applications such as Fuel systems, E-vac systems, and Vacuum/boost...

Hawks 90° Rubber Hose Fittings are designed with 360 degrees Swivel Ends. -8 AN Rubble Hose End. -8 AN Female. E-85 compatible. These fittings can be used on a variety of applications such as Fuel systems, E-vac systems, and Vacuum/boost...

Hawks 45° Rubber Hose Fittings are designed with 360 degrees Swivel Ends. -10 AN Rubble Hose End. -10 AN Female. E-85 compatible. These fittings can be used on a variety of applications such as Fuel systems, E-vac systems, and Vacuum/boost...