Product Description:
Hawks Motorsports is pleased to offer our clients the following.
These new reproduction molded rubber gaskets fill the gap between the rear quarter panels and tail lamp assemblies on compatible 1982-1992 Chevrolet Camaro models. The pair helps limit water, leaves and road debris from entering the seam while restoring a finished original-style rear appearance.
| Feature | Product specification |
| Producer | Hawks Restoration Parts |
| Product type | Tail lamp-to-body gasket pair |
| Vehicle application | 1982-1992 Chevrolet Camaro |
| Reference | Factory-style application |
| Condition | New reproduction |
| Quantity | One pair |
- One driver-side molded rubber gasket
- One passenger-side molded rubber gasket
- Application-specific left and right profiles
Body-Seam Protection
The gaskets close the exposed seam between each tail lamp and adjacent bodywork.
Matched Pair
Both sides are supplied so the rear lamp installation can be serviced consistently.
Condition Check
Inspect the lamp housings, studs, body flanges and water-management areas while the assemblies are removed.
| Year / application | Required configuration |
| 1982 Chevrolet Camaro | Factory-style rear tail lamp assemblies |
| 1983 Chevrolet Camaro | Factory-style rear tail lamp assemblies |
| 1984 Chevrolet Camaro | Factory-style rear tail lamp assemblies |
| 1985 Chevrolet Camaro | Factory-style rear tail lamp assemblies |
| 1986 Chevrolet Camaro | Factory-style rear tail lamp assemblies |
| 1987 Chevrolet Camaro | Factory-style rear tail lamp assemblies |
| 1988 Chevrolet Camaro | Factory-style rear tail lamp assemblies |
| 1989 Chevrolet Camaro | Factory-style rear tail lamp assemblies |
| 1990 Chevrolet Camaro | Factory-style rear tail lamp assemblies |
| 1991 Chevrolet Camaro | Factory-style rear tail lamp assemblies |
| 1992 Chevrolet Camaro | Factory-style rear tail lamp assemblies |
Model, trim and equipment availability can vary. Compare the original component, mounting location and product photographs before ordering.
- Disconnect the battery and protect the painted rear body surfaces.
- Remove the tail lamp assemblies using the factory service procedure.
- Document gasket orientation before removing the originals.
- Clean the lamp and body contact areas without damaging paint or plastic.
- Position the driver- and passenger-side gaskets correctly.
- Reinstall the lamps evenly and inspect the perimeter for gaps.
Are both sides included?
Yes. The listing contains one driver-side and one passenger-side gasket.
What do the gaskets seal?
They fill the exterior seam between the Camaro tail lamp assemblies and the body.
Will they repair a cracked lamp housing?
No. Cracked lenses, housings, studs or mounting surfaces require separate repair or replacement.
Should sealant be added?
Follow the factory service procedure and product instructions; do not substitute excessive sealant for correct gasket alignment.
Do these fit Firebird tail lamps?
No. This pair is listed for 1982-1992 Chevrolet Camaro rear lamps.
