Product Description:
This new reproduction four-piece gasket set is designed specifically for the 1991-1992 Chevrolet Camaro Z28 high-rise rear spoiler.
Molded rubber gaskets replace the deteriorated factory foam seals between the spoiler and body, helping limit moisture intrusion, protect the finish and restore a clean spoiler-to-panel interface.
| Feature | Product specification |
| Producer | Hawks Restoration Parts |
| Product type | Rear spoiler gasket set |
| Vehicle | 1991-1992 Chevrolet Camaro Z28 |
| Spoiler requirement | Factory-style high-rise spoiler |
| Material | Molded rubber |
| Original style | Four spoiler-to-body seals |
| Condition | New reproduction |
| Quantity | Four-piece set |
| Application | Required configuration |
| 1991-1992 Chevrolet Camaro Z28 | High-rise rear spoiler only |
| Camaro RS or low three-piece spoiler | Not applicable |
- Four rubber spoiler-to-body gaskets
- Contours for the 1991-1992 Z28 high-rise spoiler locations
- Reusable factory-style screw attachment provisions
Rear spoiler, body panels, weatherstrip adhesive and refinishing materials are not included.
Rubber Upgrade
The reproduction seals use durable rubber in place of the fragile original foam, providing a serviceable weather barrier while retaining the intended contour.
High-Rise Spoiler Only
This set is not for the Camaro RS or the low three-piece spoiler. Confirm the vehicle has the 1991-1992 Z28 high-rise design before ordering.
Protect the Painted Surfaces
Water and debris trapped beneath loose spoiler feet can damage the finish. Clean and inspect every contact area before installing the new seals.
- Park the vehicle on a level surface, switch off the ignition and allow the vehicle to cool.
- Photograph the original component and note its position before removal.
- Remove the old part carefully without damaging the surrounding painted or molded surfaces.
- Compare the reproduction with the original and verify the application before final installation.
- Clean the contact area and correct any damaged attachment points before fitting the new component.
- Install the replacement evenly in its intended location without forcing or distorting it.
- Close or operate the related panel slowly and check alignment, clearance and contact.
- Reinspect the installation after the first drive and make any service-manual adjustments required.
How many gaskets are included?
Four spoiler-to-body gaskets are included.
What material are they made from?
They are molded from rubber rather than the original-style fragile foam.
Do they fit a Camaro RS spoiler?
No. The set is for the 1991-1992 Z28 high-rise rear spoiler only.
Is the spoiler included?
No. This listing includes the gasket set only.
Is adhesive required?.
Hawks recommends a light application of weatherstrip adhesive for added security; follow the adhesive maker’s instructions
