Product Description:
Hawks Motorsports is pleased to offer our clients the following.
Donald Thump Truck Camshaft, 214/224 .550/.550-inch 108+2 LSA for Gen III/IV LS truck-engine configurations. The cam specification is 214/224 .550/.550-inch 108+2 LSA. Match the actual cylinder heads, compression, pistons, spring installed height and valvetrain before selecting this cam. Tuning is required.

| Feature | Product specification |
|---|---|
| Condition | New |
| Cam specification | 214/224 .550/.550-inch 108+2 LSA |
| Attachment | Three bolt |
| Calibration | Tuning required |
| Package | Cam only |
| Application | Gen III/IV LS truck-engine configurations |
| Hawks part number | HT-THUMPCAM-TRUCK |

| Year | Vehicle | Required configuration |
|---|---|---|
| Configuration specific | Gen III/IV LS truck-engine configurations | Compare the exact component and selected order options |

- One Donald Thump three-bolt camshaft

The low-lift truck profile is described for compatible 4.8L/5.3L/5.7L/6.0L combinations with approximately 1,200-6,500 rpm range. Kit application lists also mention rectangle-port trucks; confirm the actual engine/head configuration rather than assuming every listed truck fits.
Single-bolt Gen IV arrangements need an appropriate three-bolt conversion. Verify any VVT/AFM/DOD changes and actual pushrod length.

Have an LS engine builder verify the cam arrangement, timing system, valve-spring setup, piston-to-valve clearance and actual pushrod length. A single-bolt application requires the appropriate three-bolt conversion. Complete required calibration and supporting engine-system changes before operation.

What cam specification is listed?
214/224 .550/.550-inch 108+2 LSA.
Is it three bolt?
Yes.
Is tuning needed?
Yes.
Are pushrods always included?
No pushrods are listed in this package.
Is piston clearance guaranteed?
No. Measure the actual engine.