Product Description:
Hawks Motorsports offers our clients this 11881 2014-2019 Chevrolet Corvette Stingray C7 ATAK Axle-Back Exhaust System, Borla. This axle-back system is designed for C7 Corvette Stingray models and uses Borla's ATAK muffler design for a more aggressive exhaust note. The system is constructed from T-304 stainless steel and features quad center-rear exhaust outlets with polished 4.25-inch round tips.
If you're looking to wake up the sound of a C7 without replacing the whole exhaust, an axle-back is a good place to start. This setup replaces the rear muffler section while leaving the factory mid-pipes and catalytic converters in place. The ATAK mufflers give the LT1 a much more serious voice when you get into the throttle, while Borla's multi-core design is intended to keep the system from becoming a constant drone machine on the highway.
This particular version is for C7s without NPP valves, or vehicles where the AFM/NPP functions have been disabled. It does not include AFM or NPP valves.
Key Features:
- Part Number: 11881
- Brand: Borla
- ATAK axle-back exhaust system
- Fits 2014-2019 Chevrolet Corvette Stingray C7
- 6.2L V8
- Automatic or manual transmission
- Rear-wheel drive
- T-304 stainless steel construction
- Single 2.75-inch inlet into each muffler
- Dual 2-inch outlets
- Four 4.25-inch round polished stainless steel tips
- Quad center-rear exhaust exit
- Patented straight-through and multi-core muffler technology
- No-drone design
- Does not include AFM valves
- Does not include NPP valves
- Non-functioning AFM actuator mounting provisions
- Can be combined with Borla X-Pipe 60548 to create a cat-back system
- Million Mile Warranty for applicable exhaust components
Fitment Applications:
Chevrolet Corvette Stingray
- 2014 Chevrolet Corvette Stingray 6.2L V8
- 2015 Chevrolet Corvette Stingray 6.2L V8
- 2016 Chevrolet Corvette Stingray 6.2L V8
- 2017 Chevrolet Corvette Stingray 6.2L V8
- 2018 Chevrolet Corvette Stingray 6.2L V8
- 2019 Chevrolet Corvette Stingray 6.2L V8
Body Styles:
- Coupe
- Convertible
Transmission:
- Automatic
- Manual
Drivetrain:
- Rear-wheel drive
Important: Borla specifies that part 11881 is not for Grand Sport models with manual transmissions. The system is intended for vehicles without NPP or vehicles where AFM/NPP functions have been disabled.
Installation Notes:
- This is an axle-back exhaust system.
- Factory mid-pipes and catalytic converters remain in place.
- Verify whether the vehicle is equipped with AFM and/or NPP before ordering.
- This system does not include AFM or NPP valves.
- Vehicles equipped with active AFM can experience a check-engine light if AFM is not disabled.
- Confirm the vehicle configuration before installation.
- Verify all components and hardware are present before beginning installation.
- Allow the original exhaust to cool completely before removal.
- Check muffler and tip clearance before final tightening.
- Properly align the quad tips with the rear fascia before completing installation.
- Additional components may be required depending on the vehicle's existing exhaust configuration.
