Product Description:
Hawks Motorsports is pleased to offer our clients the following. ACCEL 36 lb/hr High-Impedance EV1 Fuel Injectors, Set of 8. These performance fuel injectors are designed to provide controlled fuel delivery and atomization for compatible fuel-injection systems. Each injector is rated at 36 lb/hr at 43.5 PSI and uses an EV1 / Minitimer-style electrical connector.
When you're putting together a performance fuel system, injector flow and electrical compatibility need to match the combination. This ACCEL set gives you eight new injectors with a low-mass disc design intended for accurate metering across a range of operating conditions. Before installing them, verify the required flow rate, fuel pressure, connector, injector dimensions, and engine-management calibration for your particular setup.
| Brand | ACCEL |
| Part Number | 150836 |
| Product Type | Performance fuel injectors |
| Rated Flow | 36 lb/hr per injector |
| Flow Test Pressure | 43.5 PSI |
| Impedance | High, approximately 14.5 ohms |
| Connector | EV1 / Jetronic / Minitimer |
| Quantity | Set of 8 injectors |
| Condition | New performance part |
Application note: This injector set is listed as a semi-universal performance application. A verified, complete year-by-year vehicle fitment list has not been established for this listing. Confirm compatibility with the engine, fuel rail, injector dimensions, electrical connector, fuel pressure, and engine-management system before ordering.
| Year | Make / Model | Required Configuration |
| Not verified | Vehicle-specific fitment unconfirmed | Verify the exact application before purchase. |
- Eight ACCEL 36 lb/hr fuel injectors.
- Injector O-rings and fine-mesh fuel strainers, as described in the product listing.
The 36 lb/hr flow rating is specified at 43.5 PSI; actual flow changes with fuel pressure. The injector body is listed at approximately 2.85 inches long and 0.970 inches in diameter, with an O-ring-to-O-ring measurement of approximately 2.39 inches. Confirm these dimensions against the original injectors and fuel-rail arrangement before installation.
ACCEL identifies this part for uncontrolled, non-emissions-controlled vehicles. Confirm applicable emissions requirements before purchasing or installing. Although the manufacturer lists gasoline and E85 use, the entire fuel system and engine calibration must be suitable for the fuel being used.
- Relieve fuel-system pressure before servicing the injectors.
- Compare injector length, O-ring positions, connector style, and fuel-rail fit before installation.
- Inspect the injector seals and fuel-system connections, and use appropriate installation lubricant on compatible O-rings.
- Check for fuel leaks before starting the engine.
- Verify injector calibration and fuel delivery with the engine-management system or qualified tuner.
How many injectors are included?
This part number is sold as a set of eight injectors.
What is the rated flow?
Each injector is rated at 36 lb/hr at a test pressure of 43.5 PSI.
What electrical connector do these injectors use?
They use an EV1 / Jetronic / Minitimer-style connector. Confirm connector and harness compatibility before ordering.
Will these fit my vehicle?
Fitment depends on the engine, fuel rail, injector dimensions, fuel pressure, connector, and engine-management system. Confirm the specific application before purchase.
Will tuning be required?
The engine-management calibration may need to be updated for the injector flow rate. Consult a qualified tuner for your setup.
