1993-2002 Firebird Formula Race Wickerbill Spoiler Extension 3 inches New Hawks Motorsports HM9302FBWB

Hawks Motorsports is pleased to offer our clients the following.

Add 3 inches of height to the compatible factory spoiler on your 1993-2002 Pontiac Firebird Formula with this Race wickerbill spoiler extension. The extension is made from gloss black plastic composite; can be painted and mounts along the existing spoiler’s trailing edge. Mounting hardware is supplied as specified below.

Fitment note: Formula spoiler only. This extension will not fit Trans Am / high-rise spoilers. Inspect the actual spoiler and brake-light arrangement on cars with replacement or modified parts.

• One Race wickerbill spoiler extension with removable protective film
• M6 x 20 mm titanium mounting hardware; select Black, Silver or Gold

Order selections: Add the Riv-Nut installation tool only when that option is selected.

This Race version extends the rear spoiler vertically by 3 inches, changing the trailing-edge profile and appearance. It is an add-on for the specified existing spoiler. Gloss black Race extension with a smooth CNC-cut edge.

The protective film helps prevent handling marks during trial fitting and installation. Keep it in place through mounting work and cleanup, then remove it before final assembly as directed in the guide.

Read the shared illustrated installation guide before drilling. It shows a Firebird example and states that the same installation steps apply across platforms. Match the actual extension, spoiler and mounting hardware before marking holes.

Open Installation PDF in a New Window

The PDF opens separately from this product page; your browser controls whether it uses a new tab or window.

1. Protect the spoiler finish with painter’s tape and trial-fit the extension. Check its alignment and any third-brake-light opening before marking the first hole.
2. Mark and drill one mounting position at a time. Check the required hole size against the selected inserts and the guide before enlarging the hole.
3. For the recommended Riv-Nut method, use the correct adapter and seat each insert in the drilled spoiler. Temporarily secure the extension before locating the next mounting position.
4. Repeat the alignment, drilling and fastening sequence for the remaining positions. Clean away drilling debris before removing the protective film.
5. Complete the final installation with the fasteners snug. Avoid excessive force: the guide warns that overtightening can spin the Riv-Nut and damage the spoiler.

Which Firebird spoiler does this fit?
The 1993–2002 Firebird Formula factory spoiler. Trans Am / high-rise spoilers are excluded.

How tall and wide is this Race extension?
It adds 3 inches above the factory spoiler and has a published length of 51 inches.

What hardware size and finishes are listed?
M6 x 20 mm titanium hardware is offered in Black, Silver or Gold.

Can the panel be painted?
The official record describes a gloss black plastic-composite panel that can also be painted.

How is it attached to the existing spoiler?
The shared guide recommends threaded Riv-Nuts installed in drilled holes. Mark, drill and secure one position at a time to preserve alignment.