Hawks Motorsports offers our clients this 1004-KIT 2010-2012 Chevrolet Camaro Gen 5 8-Rib Drive Conversion Kit with Standard-Diameter Damper, Innovators West. This kit converts the compatible 2010-2012 Camaro accessory drive to an 8-rib belt system and includes a standard-diameter harmonic damper.

If you're building a fifth-gen Camaro to make more than stock power, the belt drive deserves the same attention as the engine parts. Going to an 8-rib setup gives the belt more surface area on the pulleys and helps keep things hooked up when you're putting serious load on the front of the motor. The standard-diameter damper keeps the factory-style crank pulley ratio, making this a solid choice when you want the stronger 8-rib drive without adding crank overdrive.

The 1004-KIT is specifically listed by Innovators West for 2010-2012 Gen 5 Camaro applications and uses the company's 8-rib standard-diameter damper. Innovators West lists the corresponding 8-rib standard-diameter damper as part 882, measuring 7.25 inches in diameter and weighing approximately 9 lbs.

KEY FEATURES:

• Part number: 1004-KIT
• Innovators West 8-rib drive conversion kit
• Designed for 2010-2012 Gen 5 Chevrolet Camaro applications
• 8-rib accessory-drive conversion
• Standard-diameter harmonic damper
• 7.25-inch damper diameter
• Approximately 9-lb damper
• Maintains standard crank pulley diameter
• Designed for high-performance and forced-induction applications
• Increased belt contact compared with the factory-style 6-rib setup
• Helps reduce belt-slip potential on high-load combinations
• Complete conversion-kit configuration

FITMENT APPLICATIONS:

Chevrolet Camaro

• 2010 Chevrolet Camaro
• 2011 Chevrolet Camaro
• 2012 Chevrolet Camaro

Application:

• Gen 5 Camaro
• Compatible factory-style accessory-drive configurations

Important: Verify the exact engine and accessory-drive configuration before ordering. This kit is specifically identified for the 2010-2012 Camaro. Later Camaro applications use different conversion kits.

INSTALLATION NOTES:

• This listing is for one 1004-KIT 8-rib drive conversion kit.
• Verify the vehicle is a 2010-2012 Gen 5 Camaro before ordering.
• Verify the engine and existing accessory-drive configuration.
• The kit converts the applicable accessory drive to an 8-rib belt system.
• The standard-diameter damper does not provide crankshaft overdrive.
• Verify belt length and routing after conversion.
• Check pulley alignment across the entire accessory drive before starting the engine.
• Inspect the crankshaft snout and keyway before installing the damper.
• Follow Innovators West installation and torque specifications.
• Verify all supplied components are present before beginning installation.
• Do not modify or permanently install components until fitment has been confirmed.
• Professional installation is recommended.